Keep an eye out for dead algae.These blooms are sometimes too small to make it to the filter so they sink to the bottom. If you’re not able to vacuum it all out, try a flocculant that will bind all the small particles together, making them easier to remove. If you add too much, you risk counteracting your chlorine’s effectiveness, not to mention you’ll have to dilute the water and sort of start all over. If you opt for regular ol’ chlorine that doesn’t contain CYA, now is when you’ll need to add some. The easiest way to keep your sanitizer in check is to use an automatic chlorinator.
This is also the point where it’s helpful to have a helper inside the pool. Have the helper hold a small Tupperware container over the existing return bulkhead. As you start cutting the liner the suction from the water leaving the pool will hold the Tupperware against intex baby float the liner and slow the amount of water leaving the pool. This will make it easier to cut since you’ll be able to see what you’re doing. There will still be some water leaking out, but not a lot. Rust is a common problem with Intex and other above ground pools.
Grab the new bulkhead and push it through from inside the pool. This should stop a significant amount of the water draining out, but there will still be some leaking out around the new bulkhead. Cut a flap of vinyl and glue it to the inside of the pool and then hang it over the edge. The flap hanging over could easily be secured to the leg with a zip tie, or even a magnet. Intex recommends using pressure treated boards instead of pavers to support the legs on their rectangular pools. The support for the legs needs to be large enough so the legs do not hang off the sides of the support, and so the legs have room to spread out as the pool is filled.
Though not as elegant as some in-ground pools, this Intex has a contemporary appearance that sets it apart from the typical pop-up pool. The exterior is a slate gray color with a matching brushed steel frame. White trim marks the waterline on both the inside and the outside. The interior, like most pools, is checkered white and blue. If you had to clear and level an area for the pool, keep in mind that your backyard might look like an eyesore until you finish the landscaping around it.
But maybe the most impressive improvement is their filtration system that they upgraded to provide better circulation and water clarity. The Ultra XTR Frame pool is what Intex considers its top-of-the-line model. It has a slew of upgraded materials to be more water-resistant and way more durable.
s are perfect for the backyard and are easy to set up and maintain. Whether you want to splash with the kids or entertain adult guests, there’s a pool for every backyard and lifestyle. Add shock to the pool once the pH and alkalinity are at good levels. Follow the instructions again on the back of the shock container for the number of gallons of water in your pool. Test the level of chlorine in your pool to ensure you added enough shock.
This sharp-looking, expansive pool from Intex is large enough for several swimmers to stretch out on rafts. It’s 24 feet wide, constructed of galvanized steel and powder-coated inside and out to prevent rust, plus there’s a three-ply liner and it comes with a sand filter pump. Also included is a durable ground cloth, a pool cover with rope ties to secure it, and a removable pool ladder. Setup is said to take about an hour, with no extra tools required and it’s easy to maintain, with routine backwashing needed every five years. If you want the most durable , a vinyl model with a premium metal frame is your best bet.