The suction fittings in this spa are sized to match the specific water flow created by the pump. Should the need arise to replace the suction fittings or the pump, be sure that the flow rates are compatible? Never operate spa if the suction fittings are broken or missing.
If there is only one wire then the control board is measuring the resistance value of the thermistor with regard to earth. Try removing the sensor and connecting an Ohmmeter between the wire connection terminal on the sensor and a bare metal part on the body of the sensor. Then either cool down the sensor or warm it up (hair dryer?) and check what happens to the resistance. Your question may be answered by our experts, sellers, manufacturers or customers who bought this product. Your question will be answered by email, please make sure you provide a correct email address. The delivery date gives you an indication of how long it will take to receive the item.
This will depend on the climate where you live and whether or not you use the spa indoors or outdoors. That said, typically inflatable spas lose heat faster than fabricated spas that have thick foam insulation. Although I included “More Expensive to Heat” in the “Cons” list below, I intex purespa should mention that this tub includes an insulated top cover and thermal floor mat to minimize heat loss. If you’re looking for a spa-like experience, keep reading to find a detailed review of the Intex 28429E PureSpa Plus 6.4 Foot Diameter 4 Person Portable Inflatable Hot Tub Spa.
Best for those who want a hot tub with a simple wireless control panel. •Turn the heater off, then press the filter and bubble buttons to lower the water temperature. Put a “temp barrier mat” between the spa floor and the ground to prevent heat loss from the bottom intex purespa of the spa and to provide better heat retention. Do not use the spa if the ambient or water temperature is 4°C (39°F) or lower. Everyone who has one of these Pure Spas raves over how easy they are to set up. It basically pumps itself up with the built-in air pump.
Turn on the spa and press the button, aim the inflation hose at the inlet/outlets on the spa tub and spa control unit to dry out any water in the piping system (see drawings 16 & 17). •Turn off and unplug the control unit, add some warm water to raise the spa water temperature above 5°C (41’F), then press the E button to heat up the water to the desired temperature. To set it up, you need to first layout the thermal ground mat in a flat area that is at least 11 feet across.
This will ensure that the water is clean and will prevent the error code E90. Best for people, who live in cold regions and need a basic configuration of a hot tub. •Connection between the hose adaptor and blower inflation outlet, and between the inflation hose intex baby float and inflation valve are loose. •Check the air pressure and release air if necessary. During very hot weather, you must check to see whether it is necessary to release some air. •Heating element failed.•Increase the temperature and attach the spa cover.